Schumacher GT12 Supastox GT

Schumacher SupaStox GT

Since the introduction of the Schumacher Supastox chassis, we’ve seen  a large number of our members race that particular chassis. Now Schumacher have released the latest version, the Supastox GT.  The car raises the bar yet again in the world of 1/12th GT12 racing.

Schumacher GT12 Supastox GT

A high performance, top quality racer that is lighter, stronger and faster than ever. The Supastox GT is easier and more consistent to drive and has a wider window of set up. A car for club racers and champions alike. Put simply, the Schumacher SupaStox GT  is faster and better.

Schumacher GT12 Supastox GT

Kit features

  • NEW – Lightweight Low Centre of Gravity CNC Alloy Motor Mounts
  • NEW – Pivot Ball Rear End with Front to Back Tube Damper for Improved Bump Riding
  • NEW – Adjustable Rear Ride Height Via Rear Axle Adjusters
  • NEW – Adjustable Front Ride Height on King Pin
  • NEW – Rear Tweak and Roll Stiffness Adjustment via springs and spring position
  • NEW – Adjustable Rear Droop with droop screws
  • NEW – Adjustable Front Droop screws
  • NEW – Shorter, Narrower and stiffer 2.5mm Carbon Fibre or 2.5mm S1 Composite Chassis
  • NEW – Small Kimbrough Servo Saver with Strengthener Included As Standard for improved Steering Geometry
  • NEW – Lightweight Front Foam Bumper and Mounting For Great Protection
  • NEW – Included Ball Bearing Front Wheels
  • NEW – Tweak Free Battery Mounting with Tape. Option Battery Strap Available
  • NEW – CNC Brass Weight Position on Rear Pod for Better Balance
  • NEW – Chassis Weight Balance Pivot Holes. For Use With U3582 Pivot Set
  • NEW – Adjustable Ackerman with Washers
  • NEW – Pivot Front Suspension With Camber, Castor, Droop And Toe-in/out Adjustment
  • NEW – Improved Ground Clearance Rear Body Mounting
  • NEW – Multiple Servo Mounting Positions
  • 70T 48 dp High Efficiency Spur as Standard
  • Chassis accepts 1S or 2S Shorty
  • CNC Alloy Drive Dog Outputs For Precision And Durability
  • CNC High Tensile, Stainless Steel Rear Axle
  • High Tensile, Stainless Steel Suspension Pivots
  • Hign Tensile Steel Hex Screws Used Throughout
  • Adjustable Steering Turnbuckles Included As Standard
  • Ball Raced Rear Axle With Rubber Sealed Bearings
  • High Quality Easy to Follow Instruction Manual
  • Large Range Of Optional 32 and 48dp Spur Gears
  • Fully Adjustable Body Mount System
  • Contact Pre-glued And Trued Foam Tyres Included, 35sh Rear and 47sh Front
  • Full Range Of Optional Colour Coded Springs
  • Accepts A Huge Range Of Industry Standard Bodyshells, Motors, Batteries, And Speed Controllers
  • Torsional Side Damping Adjusted with ‘O’ Rings or Speed Secret Optional Tube Dampers.

There are three versions of this chassis available:

  • K154 – SupaStox GT Kit – S1 with differential
  • K157 – SupaStox GT Kit – Carbon fibre chassis
  • K158 – SupaStox GT Hot Rod – S1

Schumacher GT12 Supastox GT

You will also need additional kit to go racing and if you are new to the hobby of RC racing then we highly recommend that you read our New to RC racing page on our site that gives you lots of information about what to buy and what NOT to buy.


Back to Top ↑